Telephone - 01926 438363

3-axis Turning (X, Z and C axis) Programmer Course – Heidenhain Control

Course duration is 3 days
																	

To ensure a positive learning experience course size is limited to 6 attendees.

Cost of course is £900.00 + VAT per attendee.


Call the Academy for availability or complete the form below

Course information

This course is for people looking to acquire the basic knowledge of how to program a 3 axis CNC Heidenhain-controlled lathe.

This is a standard level course and attendees need to be familiar with engineering & machine tools with some understanding of their layout and configuration. An understanding of component drawings would also be advisable.

Specific course content includes:

  • Introduction and review of a lathe and its layout
  • General safety and best-practice instruction
  • Overview of codes used in programming - i.e. G Codes, M Codes
  • Understanding CNC programs - structure and content
  • Explanation of Tool Change positions G14~G140
  • Programming with absolute and incremental values
  • Using Tool Editor with geometry & radius offsets
  • Tool nose radius compensation & vector quadrants
  • Rapid traverse and other feed-rate commands i.e. mm/rev & mm/min.
  • Creating simple programs using simulation - and how to edit them
  • Using multi repetitive cycles - G code and ICP Units
  • Face Drilling, Reaming, Tapping & Boring using C axis
  • Face Milling, Pockets,Grooves & Spigots and Irregular Contours Using C axis.
  • Side Drilling, Reaming, Tapping & Boring using C axis
  • Side Milling, Pockets, Grooves & Spigots and Irregular Contours Using C axis.
  • Writing extended programs to also include sub programs & sub routines

This course is run at the Mills Mills CNC Training Academy's facility in Leamington or can be held at a customer's facility. (Charges will be different to above.)

This course is theoretical in nature using Heidenhain touch screen simulators.

If training is required at a customer's facility, it is important that attendees have a room with a projector & whiteboard facilities.

To find out more about this course call the Mills Mills CNC Training Academy on 01926 438363.

Safety Shoes and other P.P.E. Equipment is not required.

Heidenhain 3-axis programmer courses run at the Mills Mills CNC Training Academy last for 3 days

  • Day 1: Start: 9.30am - Finish: 5.00pm
  • Day 2: Start: 9.00am - Finish: 5.00pm
  • Day 3: Start: 9.00am - Finish: 4.00pm

 

Light lunch and soft drinks are provided. For special dietary requirements please contact the Mills Mills CNC Training Academy on 01926 438363 or email sales@cnctrainingacademy.co.uk

Do you have a question about this course?

 
Where to find us

Mills CNC Limited
The Mills CNC Technology Campus,
Tachbrook Link,
Tachbrook Park Drive
Leamington Spa, Warwickshire, CV34 6SN

©2020 Mills CNC Training Academy | Privacy | Terms and Conditions | Contact Us